Honda replaced the original City in 1986 (designated GA1), with an update in 1989 (GA2). This model was produced until 1994. The Fit name also first appeared as a trim variant of the City. There was no convertible model. In most European markets, the City's market position was left open until filled by the Honda Logo in 1999. The third generation Honda City, codenamed SX8 but with chassis codes 3A2 (1.3) and 3A3 (1.5), was based on the EK Civic platform. It was designed for and sold in the South East Asian market only. First production began in an all-new plant in Ayutthaya, Thailand, in April 1996. From the beginning, these Thai Citys had more than 70% local content. The bumpers were constructed in three separate pieces to allow for easier shipping from Japan. There were originally a lower grade LXi and a higher-spec EXi available. This City is still a subcompact slotting beneath the Honda Civic, but a four-door sedan model instead for developing markets in Asia, and was built in Pakistan, Thailand, Malaysia, Indonesia, Philippines and India. A revised, face-lifted third-generation City was released in 2000, called the "City type Z" in some markets. By 2001 a model powered by Honda's 1.5 liter VTEC engines (VTi) appeared, featuring a rear-stabilizer for better handling. The facelift model received new front- and taillights, as well as one-piece bumpers. The third generation city had fuel injected SOHC 16-valve D-series engines, namely variations of the D13B and D15B. The original 1.3 L (1,343 cc) D13B produced 95 PS (70 kW) at 6,400 rpm for a claimed top speed of 171 km/h (106 mph) and 0–100 km/h in 11.3 seconds. This was later complemented by the 1.5 litre D15B, which was reduced in power for the Asian markets where the car was sold, but had a power to weight ratio superior to the competition nonetheless. The D15B engine also arrived in a version featuring VTEC, with an output of 115 PS (85 kW). The VTEC-engined City has a 0–100 km/h time of around 10 seconds. The car had a sporty suspension set-up. In many of its intended markets it was one of very few sub-compacts with fully independent rear suspension (dropped in the later models due to its high cost) which allowed for greater feedback and enhanced handling.Honda City
Honda replaced the original City in 1986 (designated GA1), with an update in 1989 (GA2). This model was produced until 1994. The Fit name also first appeared as a trim variant of the City. There was no convertible model. In most European markets, the City's market position was left open until filled by the Honda Logo in 1999. The third generation Honda City, codenamed SX8 but with chassis codes 3A2 (1.3) and 3A3 (1.5), was based on the EK Civic platform. It was designed for and sold in the South East Asian market only. First production began in an all-new plant in Ayutthaya, Thailand, in April 1996. From the beginning, these Thai Citys had more than 70% local content. The bumpers were constructed in three separate pieces to allow for easier shipping from Japan. There were originally a lower grade LXi and a higher-spec EXi available. This City is still a subcompact slotting beneath the Honda Civic, but a four-door sedan model instead for developing markets in Asia, and was built in Pakistan, Thailand, Malaysia, Indonesia, Philippines and India. A revised, face-lifted third-generation City was released in 2000, called the "City type Z" in some markets. By 2001 a model powered by Honda's 1.5 liter VTEC engines (VTi) appeared, featuring a rear-stabilizer for better handling. The facelift model received new front- and taillights, as well as one-piece bumpers. The third generation city had fuel injected SOHC 16-valve D-series engines, namely variations of the D13B and D15B. The original 1.3 L (1,343 cc) D13B produced 95 PS (70 kW) at 6,400 rpm for a claimed top speed of 171 km/h (106 mph) and 0–100 km/h in 11.3 seconds. This was later complemented by the 1.5 litre D15B, which was reduced in power for the Asian markets where the car was sold, but had a power to weight ratio superior to the competition nonetheless. The D15B engine also arrived in a version featuring VTEC, with an output of 115 PS (85 kW). The VTEC-engined City has a 0–100 km/h time of around 10 seconds. The car had a sporty suspension set-up. In many of its intended markets it was one of very few sub-compacts with fully independent rear suspension (dropped in the later models due to its high cost) which allowed for greater feedback and enhanced handling.
Subscribe to:
Post Comments (Atom)
0 comments:
Post a Comment